8
9. Automatic Shut-Off
To preserve battery life, the Speak & Learn Puppy will
automatically enter sleep mode after approximately 45
seconds without input. The unit can be turned on again by
pressing any button.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions,
please follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from direct
heat sources.
3. Remove the batteries if the unit will not be in use for an
extended period of time.
4. Do not drop the unit on a hard surface and do not expose
the unit to moisture or water.
Environmental Phenomena
The unit may malfunction if subjected to radio-frequency
interference. It should revert to normal operation when the
interference stops. If not, it may become necessary to turn the
power Off and back On, or remove and reinstall the batteries.
In the unlikely event of an electrostatic discharge, the unit may
malfunction and lose memory, requiring the user to reset the
device by removing and reinstalling the batteries.
To Next Page
Loading...
Need help?
General