Leatt 6.5 - Optional Neck Brace Strap; Proper Care and Maintenance; In the Event of a Crash; Crash Feedback Procedure

Copyright © 2021, Leatt
®
Corporation
7
GB
Proper care and Maintenance
Make it a habit to inspect your Leatt-Brace
®
as you would other safety equipment. Frequently worn braces should
be discarded and replaced every two years. Do not make any alterations or modications to your Leatt-Brace
®
.
If you lose or damage adjustment pins, hinges, struts, padding, or other components, purchase replacements
from Leatt Corporation. Keep your Leatt-Brace
®
clean by washing it with plain soap and water. Solvents, abrasive
cleaners, and high heat can damage the brace and reduce its eectiveness just when you need it the most.
In the event of a crash
1. The Leatt-Brace
®
is designed to absorb potentially injurious forces and redistribute them using Alternate
Load Path Technology
®
. Although components of the Leatt-Brace
®
may feel rigid to the touch, the front and
rear platforms and thoracic struts are engineered to yield under load.
2. The Leatt
®
Corporation would like to hear from you if you have been involved in a crash event. The feedback is
used to advance the understanding of crash dynamics in the Leatt
®
Lab and assist in improving our products.
3. In event of a crash, if you have supporting footage, photos or medical information, gather all the supporting
information and submit it to the address below.
4. After evaluation by the Leatt
®
Lab and subject to the Leatt
®
Lab discretion incentives may be oered for fully
completed Injury Assessment forms;
You can ll in our online injury assesment form at: www.leatt.com/customer-support/accident-form/
Technical information
Leatt
®
5.5 / 6.5 has been tested against the manufacturer’s specications and EC Type-Examination certication
has been issued by RICOTEST Via Tione, 9 - 37010 Pastrengo (VR) Italy, Notied Body No. 0498. It is CE marked to
denote compliance with the EU Personal Protective Equipment Regulation 2016/425.
LIMITED WARRANTY
YOUR LEATT-BRACE® IS WARRANTED TO BE FREE OF DEFECTS IN MATERIALS OR MANUFACTURING FOR
ONE YEAR FROM THE DATE OF PURCHASE. THE LEATT-BRACE® IS DESIGNED TO YIELD OR BREAK UNDER
CERTAIN CONDITIONS OF USE, SO DAMAGE CAUSED BY ACCIDENTS, FALLS, ABUSE OR MISUSE IS NOT
COVERED BY THIS LIMITED WARRANTY.
TO MAKE A WARRANTY CLAIM, GO TO WWW.LEATT.COM OR SEND AN EMAIL TO WARRANTY@LEATT.COM.
LEATT CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Back
Front
9
a.
d.
c.
b.
The brace strap is easily attached through opening the ends of the straps (9 a & b), looping them through the strap
openings and then closing them again (9.c & d). Please make sure you have the straps secure on the front and back
of the brace(9.e).
Optional Neck Brace Strap