LECTRICEBIKES.COM | 602.715.0907 27
Pedal Assist and Shifting Gears
You should shift gears on your Lectric eBike in the same way you
would shift with a normal bicycle.
By selecting the proper gear, you can increase your speed and range
while applying the same amount of force.
You should test the range of your Lectric eBike under different
conditions and terrains before planning longer and more demanding
trips. Refer to the Range Estimates section below to learn about the
factors to consider when planning longer rides.
When the bicycle has not been used for 10 consecutive minutes, the
display will automatically shut down. The PAS and throttle features
will no longer work when the display is OFF.
To prevent serious injury or death:
• Do not allow yourself to be distracted by the display. If you do not
concentrate on the trafc around you, you risk being involved in a
crash. If you want to change any settings other than the PAS level,
always stop before changing the settings or display.
• Set the display brightness such that you can adequately see
important information like speed or warning symbols. Display
brightness that is incorrectly set can result in dangerous
situations.
• The electrical components on the bicycle are not waterproof. The
electrical components on the bike have an IP rating of 65.
• Check the display and plug. If damage is detected, do not use the
display. A damaged display or cables or plugs increase the risk of
a re, explosion and personal injury.
• Do not disassemble the display. There are no user serviceable
parts inside the display. Incorrect reassembly or damage may
result in re or explosion.
WARNING!
To Next Page
