LECTRICEBIKES.COM | 602.715.0907 50
After 100 miles, or 5 full battery charge cycles, have the following
services performed at a bicycle shop:
• Brake cables may need to be adjusted and tensioned properly.
• All hardware should be adjusted to the specied Tightening Torque
(p. 19). If any hardware is damaged, it may need to be replaced by
a bicycle mechanic.
• Check all items on the monthly service list above.
• Check tire tread for excessive wear. Replace if necessary.
• Check electrical connectors and cable housings are secured away
from moving parts and are free from damage. Replace
if necessary.
• Inate tires to pressure within recommended range printed on
tire sidewalls.
• Lubricate chain.
• Check that all hardware is tightened to the torque specications
listed in the Tightening Torque (p. 19) section of this manual.
• Check your brake pads for signs of wear. Replace if necessary.
• Clean the bicycle with low residue cleaner and dry completely.
Lubricate after cleaning where necessary.
• Check spoke tension and adjust if necessary. See Tightening
Torque (p. 19).
Tune-Ups
100 Mile Tune-Up
Quarterly (or about every 750-1500 miles)
Monthly (or about every 250-500 miles)
Do not submerge your Lectric eBike or its components in
water, or use a pressure washer to clean.
Cleaning
Clean your Lectric eBike carefully with a soft, damp cloth (using only
mild soap and water). Rinse with water. The electrical components on
your Lectric eBike are IP 65 rated.
To Next Page
Loading...
