LECTRICEBIKES.COM | 602.715.0907 7
WARNING!
Helmets
• Always wear a helmet. Wearing a helmet properly may reduce the
risk of a severe head injury. When riding, always wear a helmet that
meets or exceeds the standards of the Consumer Product Safety
Commission (CPSC). Check the manual that comes with your
helmet.
• Ensure your helmet ts your head and is properly secured. If you
attach a child’s seat to the bicycle, the child must wear a properly
tted helmet at all times.
• Read your helmet manual to make sure it is adjusted properly
according to the tting instructions provided by the helmet
manufacturer.
• A proper-tting helmet should be comfortable and should neither
rock forward/backward nor side to side.
• Refer to the tightening torque section (p.19) of this manual in order
to properly torque the chain tensioner and make sure it is in the
correct position for proper function. If the chain is too tight and you
are walking the bike in PAS 1-5, the front chainring and pedals will
move which will cause PAS to activate. The acceleration from this
activation could cause a crash. To avoid this, walk the bike in PAS 0.
Pre-Ride Safety Check
• Before each ride, inspect your eBike for damage. If damage is
found, do not ride.
• Verify that the front and rear axles are secure.
• Verify that the handlebar and seat clamps are closed and
tightened to the torque specied in the Owner’s Manual.
• Verify that both the handlebar latch and frame latch are secure
and fully closed.
• Check tire pressure of both wheels.
• Pull the brake levers to ensure the brakes are working properly
and adjust if necessary.
• NEVER exceed the maximum total weight limit of 275 lbs. (125
kg). The rear rack can hold a maximum of 55 lbs. (25 kg). As an
example, if you have 40 lbs. (18 kg) of cargo, then the maximum
weight of the rider would be 235 lbs. (107 kg)
To Next Page
Loading...
Need help?
General
