EasyManuals Logo

Lectric XP Step-Thru 2.0 User Manual

Lectric XP Step-Thru 2.0
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33YOUR FIRST RIDE
CONGRATULATIONS!
You can now cruise at speeds of up to 28 mph on your Lectric XP!
Exercise increased caution as riding at higher
speeds poses an increased safety risk and may
result in serious injury or death. Always wear a
helmet and obey the rules of the road.
Battery Capacity Display
On the top of the LCD display a battery indicator bar can be
found which is labeled “energy bar”. This battery indicator shows
the estimated charge level left in the bikes battery. As the
battery depletes, tick marks will begin to disappear according to
approximately how much charge in the battery has been used. The
various charge level indicator states are shown below. The battery
display will ash when there is no charge remaining.
Note: The energy bar will not always be accurate. The energy bar
updates every few minutes based on the current voltage of
the battery.
FULL EMPTY
4. Press and hold the plus and minus buttons on the control pad
until the main screen is shown once again.
5. Power the bike off by holding the power button to save the
settings you have just changed.
TIPS WHEN RIDING TO INCREASE RANGE
To get the maximum range out of your bike there are some simple
things you can do:
Ride in a lower level of pedal assist
Use lower assist levels and pedal when climbing hills
Pedal when starting from a standstill
Set your max speed lower than 20 mph on the LCD display

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lectric XP Step-Thru 2.0 and is the answer not in the manual?

Lectric XP Step-Thru 2.0 Specifications

General IconGeneral
BrandLectric
ModelXP Step-Thru 2.0
CategoryScooter
LanguageEnglish

Related product manuals