LECTRICEBIKES.COM | 602.715.0907 18
Charge Battery Before First Use
Locate the charging port on the side of the battery packs. Use this
port to charge when the battery packs are installed or not installed.
If you have two batteries on your bike, you should charge both. Each
battery must be charged by a Lectric charger. You should fully charge
your battery/ batteries before your rst ride.
See Battery Pack section (p. 37) for additional information.
Fire and explosion hazards. Never leave your battery pack
unattended while charging to prevent serious injury or death.
Front and back adjustment: Loosen nuts on both sides of the saddle
rails. Make sure the clamp mechanism is clamping on the straight
part of the saddle rails and is not touching the curved part of the rails.
Ensure that you are using the recommended torque on the clamping
fastener(s). See Tightening Torque (p. 19).
Seat angle adjustment: Most people prefer a horizontal seat; but
you may prefer the seat nose angled slightly up or down. Loosen
the clamp bolt to allow any serrations on the clamp mechanism to
disengage before changing the seat angle, and to fully re-engage the
serrations before you tighten the clamp bolt to the recommended
Tightening Torque (p. 19).
Adjust Seat Position
WARNING!
Always tighten fasteners to the
correct torque to prevent serious
injury or death. Bolts that are too
tight can stretch and deform. Bolts
that are too loose can move and
fatigue. Either condition can lead
to a sudden failure of the bolt and
result in a crash. See Tightening
Torque (p. 19).
To Next Page
Loading...
Need help?
General