LECTRICEBIKES.COM | 602.715.0907 42
To Charge:
Plug the cable from the charger into the port on the side of the
battery packs.
Plug the charger power cable into an electrical mains wall socket.
Use only the supplied input connection: standard AC power cord
when connecting to the household electrical supply.
Plugging in one battery while both batteries are mounted to the bike
will only charge the battery that is plugged in.
Note: The charging process is only possible when the temperature
of your Lectric eBike battery is within the permitted charging
temperature range.
Note: PAS is deactivated during the charging process.
After charging is complete and the light on the charger is green,
disconnect the cable from the battery port and power cord from
wall socket. If you have charged the batteries in the bicycle frame,
carefully insert the plug after charging, so that no dirt or water can
enter the battery ports.
To prevent serious injury or death:
• Only place battery packs on clean surfaces. Avoid getting dirt, e.g.
sand or soil, in the charging port and contacts.
• Do not charge or use battery packs if there is damage. Contact
Lectric eBikes to order a replacement
Your bike comes with a 48V lithium ion battery and a unique set of
keys that are used to lock it to the frame.
There is the option to mount a second battery (this is the auxiliary
battery) behind the seat tube to increase range on your XPremium.
The auxiliary battery will come with a unique set of keys.
If you have both the primary battery and the auxiliary battery, each
battery must be used with its unique set of keys.
Installing and Uninstalling Battery Packs
WARNING!
To Next Page
Loading...
Need help?
General