Page 1
INSTRUCTION MANUAL
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product,
consult a competent electrician
Note:
Product technical information and specification may change over time without prior notification. For the latest technical
information please visit our web site www.robus.com or robusdirect.com
Issue 1 100918
Type 1: Control the single colour LED strip
The Installation must be carried out by a qualified electrician
-20°C < Ta < +40°C, Battery: DC3V (AAA*2), Remote Control Distance: 20m
LED Group Australasia
9/210 Queensport Road North Tel: 07 3890 5444
Murarrie Fax: 07 3890 4777
QLD 4172 Email: purchases@robus.com.au
Australia Website: www.robus.com.au
RVA4Z-RC
VEGAS 4 ZONES, RF REMOTE CONTROL FOR SINGLE COLOUR,
RGB AND RGBW LED FLEXI STRIPS
Set Key
OFF
DIM Ring
Night light - 10% brightness
Brightness - (5 levels)
Brightness - (1024 levels)
Speed -
Zone selection
Brightness - (1024 levels)
Speed +
Zone indicator
Brightness + (5 levels)
Mode
ON
RF signal indicator
Name Description
SET Non function
Turn on
Turn off
Dim down brightness along with clockwise direction
2 modes in total : flash and fade
Night light hot key: 10% brightness
Brightness – by 5 levels (10%, 30%, 50%, 70%, 100%).
Brightness + by 5 levels (10%, 30%, 50%, 70%, 100%).
Brightness – by 1024 levels. Long-press can get fast adjusting.
Brightness + by 1024 levels. Long-press can get fast adjusting.
Speed down for dynamic mode (100 levels). hold on the key to get fast adjusting.
Speed up for dynamic mode (100 levels). hold on the key to get fast adjusting.
Zone selection, hold on the key in 2 seconds to get “all-control”
I
O
DIM ring
M
W
-
+
B-
B+
S-
S+
Zone
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product,
consult a competent electrician
Note:
Product technical information and specification may change over time without prior notification. For the latest technical
information please visit our web site www.robus.com or robusdirect.com
Type 2: Control the LED strip of CW + WW
The Installation must be carried out by a qualified electrician
Set Key
OFF
CCT Ring
Night light - 10% brightness
Brightness - (5 levels)
Brightness - (1024 levels)
Speed -
Zone selection
Brightness - (1024 levels)
Speed +
Zone indicator
Brightness + (5 levels)
Mode
ON
RF signal indicator
Name Description
SET Non function
Turn on
Turn off
Tunable LED CCT between 100% CW and 100% WW
4 modes in total: all flash, 2 color flash, all fade, 2 color fade.
Night light hot key: 10% brightness
Brightness – by 5 levels (10%, 30%, 50%, 70%, 100%).
Brightness + by 5 levels (10%, 30%, 50%, 70%, 100%).
Brightness – by 1024 levels. Long-press can get fast adjusting.
Brightness + by 1024 levels. Long-press can get fast adjusting.
Speed down for dynamic mode (100 levels). hold on the key to get fast adjusting.
Speed up for dynamic mode (100 levels). hold on the key to get fast adjusting.
Zone selection, hold on the key in 2 seconds to get “all-control”
I
O
CCT ring
M
W
-
+
B-
B+
S-
S+
Zone
To Next Page
Need help?
General