SP107E Digital Music Controller
APP: LED Chord
[1] Contents
SP107E digital music controller
Small flat head screwdriver
Audio splitter
Barrel connector lead
[2] Wiring
2.1. To get started, unravel the LED strip from the roll. Connect the wires to the terminals in the controller
and tighten the screws to secure the connection. (Figure 1.)
Please be aware of the arrows on the flex strip. The direction indicates the flow of current. Make
sure that you are connecting from the back end of the arrow. Reversing this will cause the strip
not to illuminate.
Figure 1.
Black wire to GND
Green wire to DAT
Red wire to VCC
Blue wire does not get connected
2.2. Connect the red and black wire leads to the input terminals of the controller (Figure 2). If your driver
has a barrel connector, plug it into the barrel connector lead then connect the lead to the controller.
Figure 2.
Black wire to GND
Red wire to VCC
[3] Audio Setup
There are two ways to set up your audio:
1. Using the audio splitter included in the controller package (Figure 3) or
2. Using the built-in microphone within the controller (no extra wiring needed) (Figure 4).
Figure 3.
Plug one end of the audio splitter into the AUX IN
of the controller and the other end into your
speaker.
Note: If your speaker is not Bluetooth operated, you will need to plug in an AUX cord from your
device to the jack located halfway through the audio splitter.
LED Lights Canada Toll Free: 1-800-677-2698
4404 97 St NW Local: 780-800-0059
Edmonton, AB T6E 5R9 1 Email: info@ledlightscanada.com
The SP108E can control up to 2048
pixels.
This can be done by running the DAT wire
in series from the end of the first strip to
the
beginning of the last flex strip.
SKU: CRT710