LED Lights Canada SP105E - User Manual

SP105E Digital Bluetooth Controller
App: Magic LED
[1] Contents
SP105E digital Bluetooth controller
Small flat head screwdriver
Wiring
2.1. To get started, unravel the LED strip from the roll. Connect the wires to the terminals in the controller
and tighten the screws to secure the connection. (Figure 1.)
Please be aware of the arrows on the flex strip. The direction indicates the flow of current. Make
sure that you are connecting from the back end of the arrow. Reversing this will result in the strip
not to illuminate.
Figure 1.
Black wire to GND
Green wire to DAT
Red wire to VCC
Blue wire does not get connected
2.2. You can now connect the driver into the controller as shown in Figure 2.:
Figure 2.
Plug in the barrel connector OR wires from
the driver to the controller.
Negative to GND
Positive to VCC
2.3. To confirm that all of your connections are successful, supplying 110V AC power to the driver should
result in the flex strip lighting up. If your lights are illuminated, please proceed.
[3] App Download and Setup
3.1. Download Magic-LED from your device’s app store (Google Play or App Store). Please ensure
that your device’s Bluetooth is turned on for Step 3.2.
3.2. Launch the app. The app will instantly display all available bluetooth devices. Select SP105E. When
the connection is successful, the top of the next page should indicate that the controller is Connected.
LED Lights Canada Toll Free: 1-800-677-2698
4404 97 St NW Local: 780-800-0059
Edmonton, AB T6E 5R9 1 Email: info@ledlightscanada.com
SKU:CTR700
The SP108E can control up to 2048 pixels.
This can be done by running the DAT wire
in series from the end of the first strip to the
beginning of the last flex strip.

Summary

Wiring

Connecting LED Strip Wires

Connect LED strip wires to the controller terminals, securing with screws and observing arrow direction for current flow.

Connecting the Power Driver

Plug the power driver's barrel connector or wires into the controller, ensuring correct polarity (positive to VCC, negative to GND).

Confirming Connections

Supply 110V AC power to the driver to verify that the flex strip illuminates correctly.

App Download and Setup

Download Magic-LED App

Download the Magic-LED app from your device's app store and ensure Bluetooth is enabled on your device.

Connect to SP105 E Controller

Launch the app, scan for Bluetooth devices, select SP105E, and confirm a successful connection.

Configure Strip Settings

In the app's settings, select RGB and WS2811, and configure the total number of pixels for your LED strip.

Enjoy LED Strips

Return to the previous page using the back button to begin using your new LED digital flex strips.

LED Lights Canada SP105E Specifications

General

Brand	LED Lights Canada
Model	SP105E
Category	Controller
Language	English