LedGlow Million Color LED Wheel Ring - User Manual

Rev. Jun-18
Million Color LED Wheel Ring Lighting Kit Installation
• Please check your state and local laws before installing this Million Color LED Wheel Well Kit. Every
state has different policies and procedures in place regarding aftermarket vehicle accessories. LEDGlow is
not responsible for any fines that you may receive while using this lighting kit. This kit is for off-road use
only.
• The installation of this kit is required to be installed by a licensed professional. The improper installation
of this kit will void all warranties.
• Prior to installation, ensure the vehicle you are installing this product on has brake dust shields that are in
good condition behind the rotors. The rotor diameter must be 13.5” or smaller and the wheel diameter 18”
or larger for the 14” kit. The rotor diameter must be 15” or smaller and the wheel diameter 20” or larger
for the 15.5” kit. Please include your caliper when measuring for fitment as larger calipers may interfere
with wheel ring mounting.
• Part of the brake system will have to be removed and reinstalled during the installation of the light kit.
Future service of the brake system will require removal of the kit.
Tool List
 Drill and Drill Bit
 Felt-tip Marker
 Screwdriver
 Pliers (Optional)
 Various Tools to Remove Brake
Components
 Pop Rivet Gun (optional)
 Jack and Jack Stands
 Cutting Wheel or Metal Saw (Optional)
 Tape Measure
 Safety Gloves
 Center Punch
 Protective Eyewear
Wheel Ring Lighting Kit Includes
 Wheel Rings (4)
 Clip-on Brackets (8)
 Mounting Brackets (20)
 Screws (20)

Summary

Million Color LED Wheel Ring Lighting Kit Installation

General Safety Warnings

Important safety precautions and legal information regarding installation and usage.

Installation Cautions

Specific warnings about parts of the brake system and wheel caliper.

Step-by-Step Installation Instructions

Initial Setup and Battery Connection

Wheel and Brake Preparation

Mounting Bracket Installation

Installing mounting brackets using self-tapping screws or bolts and ensuring proper clearance.

Bracket Installation Tips

Pre-fitting Ring and Clearance Check

Final Ring and Bracket Securing

Securing the wheel ring to installed brackets using clamp-on snaps.

Wiring and Final Assembly

Securing wire rings, routing wires, replacing dust shields, and mounting the control box.

Controller Installation

Power Wire Connection

Controller Wiring Tips

Ground Connection

Battery and Test

Reconnect the battery and test the system for operation.

LedGlow Million Color LED Wheel Ring Specifications