Version 05112017
7
Step 03:
Step 02B:
Cycle through some different effects on you RGB DMX Controller to ensure each
section of RGB LED tape light behaves according to how you’ve addressed the
RGB DMX Decoders.
NOTE: If you notice sections of RGB LED tape light are cycling through effects slower than
other sections even though the sections are addressed the SAME, you may need to turn off the
delay setting for those RGB DMX Decoders. This can be done by simply holding “Button 1” and
“Button 3” until you see “P-c” flashing on the digital display. While “P-c” is still flashing, hold
down “Button 1” and “Button 3” again, until the digital display goes back to the address. Check
the sections of RGB LED tape light to ensure they are synchronized.
First RGB DMX Decoder:
Press and hold “Button 1” until the digital display begins to flash. While the digital
display is flashing, press “Button 1” until the numeric value reads “0” (zero). Then,
press “Button 2” until the numeric value reads “0” (zero), as well. Finally, press
“Button 3” until the numeric value reads “1” (one). Press and hold “Button 1” to
save your selection. The digital display should read “001”, or address 1.
Second RGB DMX Decoder:
Repeat the same process you followed for the first RGB DMX Decoder, but instead
of setting the ones place value at “1” (one), set it to “2” by pressing “Button 3”
until the numeric value reads “2”. Press and hold “Button 1” to save your selection.
The digital display should read “002”, or address 2.
Any Additional RGB DMX Decoders:
Repeat the same process you followed for the second RGB DMX Decoder, setting
the address differently each time and in sequential order (ex: 003, 004, 005,
etc.). You may adjust the tens place value and/or the hundreds place value, if
need be (ex: 010, 100, 150, etc.).
For additional assistance, please contact LEDI’s Design Department at
(832) 717-2710, or designs@ledinspirations.com.
To Previous Page
Loading...