LEDLux LL0256 - Page 7

Advanced Options Mode 2 (Through PRG)
With power off status, long press
to access advanced settings, to switch between
one setting to another then use the key
Short press or to change options
After finishing the setting,
wait about 5 seconds to exit
NO
A1
A2
A3
A4
A8
A6
A7
A5
A9
Options
Temperature Calibration
Start/Stop
temperature difference
Child lock
Integrated sensor Single Sensor
Frost protection
Maximum Limit
High temperature protection
Low temperature protection
if the internal temperature is
higher than that set
heating will be stopped
if the internal temperature is
lower than that set
heating will be stopped
Programmable Week
0 represents the valve is controlled by the thermostat
1 the valve is not controlled by the thermostat, it is always closed
0 closed, 1 open. When the valve is continuously closed
for over 100 hours, it will be open for 3 minutes。
0-GA ： valve switch protection is about 3 sec.
1GB ： valve switch protection is about 5 sec.
Degree Celsius or degree Fahrenheit
Once you have reached B5, press the key several times
button and keep it pressed for a few seconds
Valve Control
Anfreeze funcon
(descaling funcon)
GA / GB opon
Restore data
from Factory
°C o °F
0: Partial
1: Total
Functions
-9 / +9°C
Default
-1°C
1°C
0
N1
5°C
35°C
P1
5°C
45°
1 5°C
~
1-10°C
30-70°C
35-70°C
5-10°C
P1: 5+2 P2: 6+1 P3: 7
+
+
-
B1
B2
B3
B4
B5
SET
SET