LEDVero T8 - Product Operation and Care; Application Guidelines; Designated Use; Maintenance and Care

[
EN ● 3
]
Version: 2.0
11.08.2017
APPLICATION
• Avoid the following adverse ambient conditions at the place of installation or during
transport:
- Moisture or high humidity
- Direct sunlight
- Extreme cold or hot temperatures
- Dust or flammable gases, vapours or solvents
- Severe vibrations
- Strong magnetic fields such as in the vicinity of machines or loudspeakers
• Please ensure that the insulation of the entire product is not destroyed or damaged.
The housing of the special transformer and lamps may not be opened!
There are no parts for you to service inside.
• Check the product for damages before each use!
It must be assumed that safe operation is no longer possible:
- if the device shows visible damages
- if the device is no longer capable of functioning
- after longer periods of storage under unfavourable conditions
- after rough handling during transport
DESIGNATED USE
LEDVero LED tubes are intended to be mounted on walls or ceilings, to provide lighting there.
This device’s approval is invalidated immediately, in the event of any technical modification
to the device.
The safety and installation instructions defined in this instruction manual must be observed!
This product meets the statutory, national and European requirements.
MAINTENANCE AND CARE
You do not need to service this product; please never disassemble it.
If you would like to clean the installed tubes (e.g. remove dust), please first cut the supply
voltage and allow the tubes to completely cool off (approx. 5 minutes).
Then, clean the tubes with a soft, dry and clean cloth.
Under no circumstances should you use any aggressive cleaning agents or chemical solutions.