6
When uniamplifying using a single-ended stereo amplifier, STEP ONE can
be used on an external processor loop of your preamplifier. It may also be
inserted between your preamplifier and power amplifier. STEP ONE may
also be placed on a tape monitor loop to “see” the effect of the unit; but for
normal operation we recommend placing the environmental processor
between your preamplifier and amplifier for optimum performance.
Be sure your entire system has been turned off for at least 3 minutes
before making connections. After connections are made:
1. Turn on sources
2. Turn on preamplifier
3. Turn on STEP ONE
4. Turn on Amplifier(s)
Always observe this turn-on sequence!
To Next Page
Loading...