4
To properly install the Ultra MonoBloc in your audio system, follow these
brief steps.
1. Location
To provide for adequate ventilation you should allow at least a couple of
inches on each side of the amplifier. Because of its large power supply,
the amplifier produces a local magnetic field that may be picked up by low
level circuitry such as preamplifiers, turntables, and the like. For this
reason you should also provide about a foot of space between your
amplifier and these low level components.
2. Power Connections
Be certain all associated equipment is turned off before making any
connections. Position your amplifier as near the final location as possible
while leaving sufficient access to its rear panel connectors. Check that the
amplifier is turned off by pressing the rocker switch on the left side. Insert
the power cord into the AC LINE INPUT on the back panel and then
connect it to an appropriate power source.
To Next Page
Loading...
Need help?
General
