with the -12dB setting initially as shown below. Further attenuation of -3, -6dB is available if needed. While
you can also further reduce the volume setting from your preamp, the goal is totally avoid clipping at all levels.
Again try to establish a Wavelet level setting of about 85dB for typical listening. With a little care you will
have minimized your noise floor and prevented input saturation. Rarely does the Wavelet need to be set
above 90dB when optimizing to the volume settings familiar from your preamplifier.
Rear Panel View of Resistive Switches
To Next Page
Loading...
Need help?
General
