2. Click settings at the top of the screen, and choose “Room
correction”.
a. With the microphone at tweeter center height, 48” away from
the left speaker, perpendicular to the speaker baffle, choose “Measure
left channel”.
b. Please wait for the process which lasts about 10 seconds.
If there is an unexpected noise, please repeat the process by clicking
“Measure left channel” again.
c. Look at the bottom of the screen- if you see an error
such as “Volume too low,” please check the connections and/or
increase the level and try again.
d. This process may take 5-10 minutes. Please be patient,
you will be prompted when the process is complete.
e. If you receive an error message that the levels are too
low, please check that both ends of the microphone cable are firmly
docked, and repeat the process, raising the volume if necessary.
f. Repeat steps a-e for the right channel
g. Click “Upload to server”- this sends the measurements to the
room correction device which calculates the ideal settings for your
speakers and automatically sends them back to your Wavelet. You can
observe progress at the bottom of the screen. This process may take 5-
10 minutes. You will be prompted when the process is complete.
-Settings
-Room correction
To Next Page
Loading...
Need help?
General
