ALLOW FOR ENOUGH SPACE TO
UNFOLD BASE IN SETUP AREA.
NOTE
BASE APPEARANCE MAY VARY DEPENDING
ON FEATURES OF THE PURCHASED PRODUCT.
NOTE
ADJUSTABLE BASE IS HEAVY.
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE.
WARNING
!
DO NOT DROP!
TEAM
LIFT
HANDLE BASE BY FRAME
ONLY. DO NOT GRAB FABRIC.
CAUTION
!
KEEP HANDS AND FINGERS
CLEAR WHEN UNFOLDING BASE.
WARNING
!
PINCH POINT WARNING!
READ ALL INSTRUCTIONS BEFORE USING.
x1 - Remote Control
x6 - Legs
FLAT
Sleepy’s Signature Adjustable Base
Setup Guide
x1 - Mattress Retainer
Open the shipping carton.
Carefully, lift adjustable base out
of shipping carton and place on
clean surface. Remove remote,
both leg boxes, power supply,
and protective plastic.
Verify contents; inspect for damage.
1
2
Fold adjustable base out at.
3
BE CAREFUL USING SHARP INSTRUMENTS. INJURY
IS POSSIBLE IF TOOLS ARE NOT USED PROPERLY.
CAUTION
!
4
Cut zip-ties (2) and remove the mattress retainer.
x1 - Warranty Sheet
x1 - Remote Guide
x1 - Setup Guide
x1 - Power supply
5
Screw all legs into the threaded inserts. HAND TIGHTEN.
HEAD
FOOT
KEEP THE DECK AND METAL FRAME
TOGETHER WHILE UNFOLDING THE BASE.
CAUTION
!
MAKE SURE ALL LEGS ARE AT THE SAME
HEIGHT, THE WIDEST LEG SEGMENT IS
SCREWED DIRECTLY INTO BASE, AND LEG
SEGMENTS ARE FULLY TIGHTENED TOGETHER.
NOTE
Stack leg
segments and
screw ends
together to adjust
height of base.
3”
2”
8”
To Next Page
Need help?
General
