Using it’s adhesive backing, stick the strip light underneath this section in the following position.
Ensure the cable is facing the right, then bend the cable down so that it is facing the back of this
section, as shown below.
30.) Bring this section above the batmobile, then locate the NC Push Board andremove the
protective paper on the back of it to expose the adhesive. With the push button facing the
front, stick the NC Push Board underneath the top cabin section in the following position.
Ensure that the NC push board is mounted exactly as shown below and aligned exactly so
that we do not have any issues reconnecting this section later.
To Next Page
Loading...
