Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies
(with the light or expansion board or effects board). To correct any issues with expansion board
ports, please view the section addressing expansion board issues on our online troubleshooting
guide.
35.) Take a 5cm Connecting Cable and connect it a spare port on the 8-Port Expansion Board.
Connect the other end of the cable to the IN port on the Flicker Effects Board (FFX).
Take a new 5cm Connecting Cable and connect it to one of the OUT ports on the Flicker Effects
Board, then connect the other end of the cable to the remaining 8-Port Expansion Board in this
kit.
To Next Page
