Repeat steps 2-3 symm at the back. LMA.
Bag 23.
Make a part. Put a F 2x2 on the table. Put a F 6x1 hor on top, at
the back, overhanging to the sides. Put two F 2x1 hor under the
overhanging sides. Put a fs 6x1 hor on top, at the back. Put a FS
2x1 hor at the front.
Repeat to make two.
Install one, as is, on the back wall, to the left of the leftmost
smooth piece.
Install the other symm at the front.
Put a 1x1 with a side button to the left, side button to the
back.
Repeat symm at the back.
Put a curved window piece ver to the left of the two PPs, the
corners to the right. Lay aside.
Bag 24. Make an underneath railing part.
Number 1.
Put a 2x1/2x1 step piece with side buttons hor on the table, side
buttons to the front.
Put another such piece symm to the back.
Connect by putting a F 2x2 in the middle.
Number 2.
Put two 4x1 with side holes ver on top, side by side.
Mount a grate on the front and on the back side buttons, upright,
hor.
Number 3.
Insert a connector from the right into the front hole.
Insert a connector from the right into the back hole.
Repeat steps 1-2 symm at the left. LMA.
Number 4.
Make a part. Put a F 2x2 with the underneath hole hor on the
table. Stack two F three-button corner pieces and put on top,
letter D (1-4-5). Put a FS 2x1 hor at the back row.
To Next Page
Loading...
