Mount two grates symm at the back.
Put a F 2x1 with a handle hor on the left end of the front row,
the handle to the front.
Put another such piece the same way to the right.
Put two more such pieces symm at the back.
Put a 2x2/2x2 corner piece on the left end, the holed side
upright and downward at the left and the button side on top of
the four left buttons of your part.
Put another such part symm at the right.
Put a FS 4x2 hor on top of your part.
Repeat steps 1-6 to make two.
Install one ver, the handles to the front and to the back at the
left, on the left disk of your main part, fs4x2 to the left.
Install the other symm at the right.
Number 4.
Put a F 4x2 from a sep bag hor on top
Number 5.
Put two FS 2x2 on top, side by side.
Flip your structure right side up and install your part as is
into the middle section, skipping two columns to the right from
the 4x1 (rather, 6x1) vertical divider. Lay aside.
Bag 31. Make a top electrical hooks part.
Number 1. Put a F 6x2 ver on the table.
Number 2.
Put a F 2x2 on top, at the back.
Put two 2x1 with cross-hole ver to the front, side by side.
Put a F 2x2 to the front.
Number 3.
Put a F 2x1 hor on top, at the front.
Repeat symm at the back.
Put two 2x1 hammer pieces ver to the front, side by side, buttons
To Next Page
Loading...
