Put a FS 2x1 with a handle hor to the back, slide to the back.
Repeat symm at the back.
Put a 1x1 wedge to the right, slide to the front.
Repeat symm at the front.
Put a F 3x1 hor at the front right corner.
Put a F 12x1 hor to the left.
Put a F 6x1 hor to the left.
Repeat steps 5-7 symm at the back.
Put a three-button corner piece at the right edge, skipping the
front row, letter H.
Put a three-button corner piece to the back, letter F. Put a f6x2
hor to the left of the two pps in the middle. Put aside.
Bag 6. Make a part.
Put a 2x2/2x2 on the table, the holed side down and the buttons
upright at the left. Put a F 1x1 with a clasp upright, hor, clasp
overhanging to the front, on the front bottom button. Put another
such piece symm at the back. Put another such piece the same way
to the top. Put another such piece symm to the front.
Put a 2x2 ribbed cylinder sideways to the left. Put a F 2x2 disk
sideways to the left. Put another ribbed 2x2 cylinder to the
left.
Put four other F 1x1 with a clasp to the left, as before.
Put a 2x2/2x2 to the left and underneath, the same way as the
first one.
Put a ringed stick hor, the ring to the left, at the front bottom
two clasps.
Put another such stick to the top, as before.
Put two more such sticks at the back, as before.
Install as is in the middle of the right side.
Bag 7.
Put a three-button corner piece on the front right corner and to
the right, letter F.
Put a FS 8x1 hor to the left, at the front edge.
Stack two F 2x1 and put hor to the left.
To Next Page
Loading...
