clasp on the bottom stick and the wedge underneath the wedge
already there.
Install the second such part to the left, upright, hor, the clasp
to the back, the wedge to the left.
Repeat step 1 with the rest of the pieces (black).
Put two of the new parts (black) to the left, as in steps 3-4.
Put the two old parts (white) to the left, as in steps 3-4.
Bag 11.
Make a part. Put a F 1x1 with a clasp from a sep bag ver on the
table, the clasp to the back. Put a wedge on top, the slide to
the right.
Repeat three times to make four. Install one upright, the clasp
to the back, the wedge to the right, on the front edge, on the
third column from the right, on top of the part from the previous
bag, the upper stick on the clasp.
Install the second such part to the left, upright, hor, the clasp
to the back, the wedge to the left.
Repeat step 1 with the rest of the pieces (black).
Put two of the new parts (black) to the left, as in steps 3-4.
Put the two old parts (white) to the left, as in steps 3-4.
Bags 12-13. Rotate your structure back to front (and left to
right) and repeat bags 10-11.
Bag 14. Rotate your structure back to front (and left to right).
Stack two 1x1 pieces and put on the front edge, skipping six
columns from the left.
Put a ridged 2x1 hor to the right, the vertical ridges to the
front.
Repeat four times.
Repeat steps 1-3 symm at the back. LMA.
Bag 15.
Make a part. Stack two 1x1 with handles, the handles on the same
side. Put a FS 1x1 on top.
Repeat to make two.
Put one on the front edge, skipping five columns from the left,
the handles to the front.
To Next Page
Loading...
