The Gun Effects Board has 3 different gun effects, which can be configured via the 3-way switch.
The effect used in the product video example is the Cannon (blaster) effect which can be set by
flicking the switch to the far right. Turn your USB Power Bank ON and choose your desired
effect. Watch the lower cannons fire away. Alternatively, you can set your desired gun effect via
flicking to any of the other switch settings.
Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies
(with the light or expansion board). To correct any issues with expansion board ports, please
view the section addressing expansion board issues on our online troubleshooting guide.
10.) We will now install the upper cannon lights. Take the upper cannon sectionand disconnect
the top as shown below, then disconnect the two cone pieces.
To Next Page
Loading...
