(with the light or expansion board). To correct any issues with expansion board ports, please
view the section addressing expansion board issues on our online troubleshooting guide.
Neaten up excess cables from the Red Bit Lights by grouping them together and twisting/folding
them into a neat bunch as shown below:
13.) We will now install lights to the inside of the cabin area. First disconnect thecorner table,
then disconnect the black plate with bar from underneath. Take a Cool White 30cm Bit Light
and with the cable facing the back, stick it underneath the table in the following position
using an Adhesive
Square. Reconnect the black plate with bar over the top of the cable, then turn the table over
and reconnect it to the cabin area.
To Next Page
Loading...
