Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies (with
the light or expansion board). To correct any issues with expansion board ports, please view the
section addressing expansion board issues on our online troubleshooting guide.
15.) Take the Negative side of the Wireless Power Connector (flat tile) and with the cable facing
the front (same way as the Bit Light Cables) connect it over the trans clear plate. Run the
cable down behind the wall, then underneath to connect it to the next port on the 12-Port
Expansion Board.
To Next Page
Loading...
