Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies (with
the light or expansion board). To correct any issues with expansion board ports, please view the
section addressing expansion board issues on our online troubleshooting guide.
19.) Take a 30cm Connecting Cable and connect it to the 12-Port Expansion Board. Pull the other
end of the cable up in to the cabin, then thread it through the middle section behind, toward
the back of the ship. Lay the cable in between studs as shown below before reconnecting
one of the white 1×2 bricks over the top. Secure down the white plate on top to close up all
gaps.
To Next Page
Loading...
