Reconnect the black technic bar to the other side of the grey round 2×2 plate, then thread the Bit
Light cable through one of the holes in the technic barrel. Pull the cable all the way out from the
other side, then reconnect the technic bar.
Note – Because the LED is installed, it will prevent you from being able to completely push in the
technic bar. Do not forcefully push the technic bar all the way in. Doing so will damage the Bit
Light.
38.) Reconnect the barrel to the section behind, then bring the cable down andunderneath the
bottom before reconnecting the jet section to the middle row on the back of the Tantive IV.
The cable should be pulled out from underneath and toward the front.
To Next Page
Loading...
