LEGO Light My Brics 10273 - Page 53

INSTRUCTIONS 53
DIRECTIONAL
CONNECT
DISCONNECT
TURN / FLIP NOTE ICON
POWER ON TEST
TWIST / BRAIDBEND / PIVOT
LEGO
®
HAUNTED HOUSE 10273 LIGHT KIT INSTALL GUIDE
43
Green Strip Light
5cm Connecting Cable
NOTE
Connect the 5cm Connecting
Cable from the Green Strip
Light to the ‘OUT’ port of the
Scary Flicker Eects Board
If you experience any issues with the
lights not working and suspect an issue
with a component, please try a dierent
port on the expansion board to verify
where the fault lies (with the light or
expansion board). To correct any issues
with expansion board ports, please view
the section addressing expansion board
issues in our troubleshooting section.
!
!