LEGO Light My Brics 10273 - Page 72

INSTRUCTIONS 72
DIRECTIONAL
CONNECT
DISCONNECT
TURN / FLIP NOTE ICON
POWER ON TEST
TWIST / BRAIDBEND / PIVOT
LEGO
®
HAUNTED HOUSE 10273 LIGHT KIT INSTALL GUIDE
62
NOTE
Ensure the Expansion is in the
following position as this will
allow the 50cm Connecting
Cable to work with the
functionality of the elevator.
CAUTION
Repeated use of the elevator may
lead to the 50cm Connecting
Cable getting tangled in the gears.
To prevent this, repeat Step 61
after several uses.
NOTE
Test the functionality of the
Elevator, ensuring it can go up
and down smoothly.
If you experience any issues with the
lights not working and suspect an issue
with a component, please try a dierent
port on the expansion board to verify
where the fault lies (with the light or
expansion board). To correct any issues
with expansion board ports, please view
the section addressing expansion board
issues in our troubleshooting section.
!
!