LEGO Star Wars Millennium Falcon 75105 LED Lighting Kit User Manual

Star_Wars_Millennium_Falcon_75105 LED Lighting Kit
Package Contents:
 2 x White 30cm Dot Lights
 2 x Blue 30cm Dot Lights
 4 x Flashing 30cm White Dot Lights
 5 x White Strip Lights
 1 x 12 Port Expansion Board
 1 x AA Battery Pack (Requires 3 x AA Batteries)
 4 x Lego Light Grey 1 x 1 Plate
 3 x Lego 1 x 6 Plate (any colour)
 2 x Lego Trans Red 1 x 1 Round Plate
 2 x Lego Trans Clear 1 x 1 Round Plate
 4 x Lego Light Grey 1 x 1 Round Brick
 2 x Lego 1 x 2 Technic Brick (minimum one light grey)
 4 x Lego Trans Red Lightsaber Bar
 1 x Lego 6 x 8 Plate or 8 x 8 Plate (light or dark grey)
Connecting Cables
 3 x 5cm Connecting Cable
 1 x 15cm Connecting Cable
 1 x 30cm Connecting Cable
Note:
Place wires on the surface or under the LEGO building blocks.
The wire can be place between the building blocks or under the block, but they should be placed between
the studs correctly.
Insert the connectors to the ports.
Be careful when you are operating, there’s only one correct way to insert, make sure the expansion board
is upward, find the soldered “=” sign on the left of the port. When you are inserting, the side which the

LEGO Star Wars Millennium Falcon 75105 LED Lighting Kit Specifications

General

Brand	LEGO
Model	Star Wars Millennium Falcon 75105 LED Lighting Kit
Category	Toy
Language	English