Lego Star Wars Microfighters 75072
Welcome to text-based instructions from LEGO for the Blind. Before you start building, here are some
terms we’ll be using:
Front: towards you.
Back: away from you.
Up: towards the ceiling.
Down: towards the floor.
Stud: the bump on a Lego brick. Example: A 2x1 brick has two studs on it.
Vertically: going from front to back.
Horizontally: going from left to right.
Upright: pointing up towards the ceiling, and down towards the floor.
Symmetrically: a mirror image. Example: If you place a 2x1 brick with technic connector on the
front wall at the right, connector to the front, and then place another such piece symmetrically on
the back wall, at the right, the technic connector of the second piece should point to the back,
since it will be placed symmetrically.
There are also abbreviations defined at the end of this file.
The clone pilot wears yellow protective goggles and grey pants. His torso is printed with a white jacket
with grey sleeves, and black suspenders, reminiscent of tentacles which hug his shoulders. His front
(stomach is printed with the exit for the suspenders/tentacles, is a large rectangle, (possibly a battery). On
the back, his suspenders go triangularly to his belt. In between them on the back is a pocket. His head is
a double-sided face, with a frown on one side, and a calm face on the other. (One is yelling, and the
other is pensive)
Steps to build:
1. Put a F 4x4 upside down on the table.
Put a F 2x2 upside down on top of the two left columns, in the middle.
Put a F 2x2 upside down to the right.
Turn the structure right side up.
Put a FS 1x1 wedge in the right front corner, slide to the front.
Repeat symm at the back.
Put a F three-button corner piece to the left and to the front, braille letter F.
Put a F three-button corner piece to the front, braille letter H.
Put a F 2x1 with the tube underneath ver to the left, on the front left corner, the tube overhanging to the
front.
Repeat symm at the back.
Put a 2x1/2x1 corner piece (with 2x1 buttons on the piece to the front, the side buttons to the left.
Put a 2x2/3x2 step piece hot in the middle of the two right columns, the 2x2 end to the left and the 3x2
overhanging to the right.
To Next Page
Need help?
General