LEGRAND QMotion Programming Instructions

www.qmoonshades.com Pensacola FL, 32514 1 -877-849-6070 1
PN 9000217
Qadvanced Roller Shade
Gen. 3
Programming Instructions
12345
CH
Multi-Channel QdR Remote
Remote Back
UP
DOWN
CHANNEL
20%
40%
60%
80%
PROGRAM
Pin Hole
Read and understand each section before performing required steps
During FIRST TIME SETUP after Step 3. TUG, a remote must be paired to the shade within 90 seconds. Otherwise, the shade
will time-out and require a Special Learn Command (Pg. 1) to pair a new remote. JOG is a short up and down movement.
Channel number is indicated on the remote by a single green LED. The “ALL” channel (all 5 green LEDs illuminated) follows
Channel 5 in the selection sequence. Shade will only respond to learned channel, or “ALL” channel.
IMPORTANT
FIRST TIME SETUP
1. INSTALL SHADE following appropriate instructions
2. PRESS and RELEASE the CHANNEL button to select a channel (1-5)
__ (Skip channel selection for Single-Channel Remotes)
3. TUG the HEMBAR 6-10 inches (Shade will JOG in response)
4. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The Channel LEDs will scroll back and forth when in program mode)
5. PRESS and RELEASE the UP button
__ (Shade will JOG, move to Upper Limit Position, then JOG again)
SETTING LOWER LIMIT
1. PRESS and RELEASE the DOWN button
__ (Shade will move to current Lower Limit Position)
2. PRESS and HOLD the DOWN button until shade JOGS
3. TUG the HEMBAR 6-10 inches (Shade will JOG in response)
4. ADJUST shade to desired Lower Limit
__ (The DOWN button is disabled while setting the Lower Limit, adjust by pressing the
___UP button or manually roll shade by hand)
5. PRESS and HOLD the DOWN button until shade JOGS
SPECIAL LEARN COMMAND
(Shade at Upper Limit Position - manually roll shade up by hand if necessary)
1. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2. PRESS and HOLD the CHANNEL button until the shade moves
3. TUG the HEMBAR 6-10 inches
__ (The shade will JOG in response)
4. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
5. PRESS and RELEASE the UP button
(Shade will JOG, move to Upper Limit Position, then JOG again)
Use Special Learn Command when:
- The shade times-out without being paired to a remote.
- A paired remote is not being used or available
- Adding a second remote to the shade
Single-Channel QdR Remote
(Channel Numbers Not Labeled)
UP
DOWN
20%
40%
60%
80%

LEGRAND QMotion Specifications

General

Brand	LEGRAND
Model	QMotion
Category	Remote Control
Language	English