This high pressure washer is designed to use a suction hose with a backflow valve to draw
surface water, such as from water tanks or ponds. To start drawing water from a body of water:
1. Fill the suction hose with water.
2. Screw the suction hose to the unit's water connection and insert it into the water source.
3. Ventilate the unit as follows:
• Switch on the device "OFF / ON"
• Unlock the trigger gun lever.
• Press the trigger gun lever, the device will turn on.
• Allow the unit to run (2 minutes maximum) until bubble-free water appears in the trigger gun.
• Release the trigger gun lever.
• Lock the trigger gun lever.
NOTE
Using the device without water for more than 2 minutes leads to damage the high-pressure
pump.
If the device does not build up pressure within 2 minutes, switch off the and follow the
instructions
in the "Troubleshooting" section.
Operating a high-pressure cleaner
WARNING
Keep a distance of at least 30 cm when using the spray jet to clean lacquered
surfaces to avoid damage.
WARNING
Make sure the on/off switch is set to the "OFF/ON" position and insert the plug into a properly
installed outlet.
NOTE
• Use the washer on a safe and stable surface in an upright position.
Connect the unit to the electrical power and water supply as described:
• Open the water supply
• Hold the spray gun with both hands.
• Point the nozzle of the chosen accessory towards the surface to be cleaned.
To Next Page
Loading...