• Unlock the trigger and depress it to vent the unit. Wait until you have a continuous stream of
bubble-free water.
• Release the trigger.
• Turn on the "OFF/ON" switch."
• Hold the spray gun with both hands. Direct the water stream toward the object to be cleaned
and squeeze the trigger.
Release the trigger gun lever; the unit will shut off and stop the water stream. There will still be
high pressure in the unit.
WARNING!
Beware of the recoil of the device when pressing the trigger!
Handling with detergent
Detergent can only be added when the unit is operated in low pressure mode.
DANGER
When using detergents, the safety data sheet issued by the detergent manufacturer must be
followed, especially the instructions for personal protective equipment.
1. Remove the cap from the clean detergent bottle. Gently pull out the built-in detergent
reservoir in the pressure washer.
2. Fill the tank with detergent specifically designed for the pressure washer.
3. Push the detergent bottle with the opening facing down.
Recommended cleaning method
• Spray the detergent sparingly on the dry surface and let it react, but do not dry the surface.
• Remove debris from the surface of the item to be cleaned using high pressure.
When finished with detergent
• Remove the detergent bottle from the machine and close the lid.
To Next Page
Loading...