To Next PageTo Next PageHow to fix a display that is not focused on Leica GEOVID 10x42 R?
If the display is not focused, it indicates that the diopter compensation is not exact. Repeat the diopter compensation process to correct this.
What to do if the Leica Binoculars display flashes or no measurement is possible?
If the display flashes or no measurement is possible, it usually means the battery is dead. Replace the battery to resolve this issue.
Why is the image not circular when viewing through my Leica GEOVID 10x42 R Binoculars?
There are several reasons why the image might not be circular when viewing through your Leica Binoculars: * The binoculars may not be properly adjusted to your personal eye spacing. Correct this by bending the binoculars about the hinged axis. * Your pupil might not be located in the binoculars' exit pupil. Adjust the position of your head, eyes, or the binoculars. * The eyepiece sleeves might not be correctly adjusted for use with or without glasses. If wearing glasses, screw in the eyepiece sleeves; if viewing without glasses, extend the eyepiece sleeves.
What to do if Leica GEOVID 10x42 R display "- - -" when measuring range?
The display showing "- - -" when measuring range with your Leica Binoculars can indicate: * The object is above or below the measuring range. Refer to the measuring range specifications. * The object is not sufficiently reflective.
General| Magnification | 10x |
|---|---|
| Objective Lens Diameter | 42 mm |
| Eye Relief | 16 mm |
| Exit Pupil | 4.2 mm |
| Waterproof | Yes |
| Rangefinder | Yes |
| Twilight Factor | 20.5 |
| Diopter Compensation | ± 4 dpt |
| Housing | Magnesium |
| Measuring Accuracy | ± 1 m |
| Prism System | Roof |
| Fogproof | Yes |
| Rangefinder Accuracy | ± 1 m |
| Battery Type | CR2 |
| Laser Rangefinder Range | 10 - 1100 m |
| Laser | Class 1 |
| Lens Coating | HDC |
| Rangefinder Range | 10 - 1100 m |
| Battery Life | Approx. 5000 measurements |
