Need help?Do you have a question about the Leica iCON grade iCP42 and is the answer not in the manual?
General| Brand | Leica |
|---|---|
| Model | iCON grade iCP42 |
| Category | Industrial PC |
| Language | English |
Congratulations on purchase and overview of the iCP42's purpose.
Locating type and serial number for contact and reference.
Explains the meaning of hazard symbols used in the manual.
Describes the iCP42's keypad, screen, and rugged enclosure for harsh environments.
Details wireless power, data transfer via IR, WLAN support, and connectors.
Lists the included iCON grade iCP42 unit.
Lists the included user manual, antennas, transport case, and USB stick.
Instructions for snapping the iCP42 onto the cradle.
Step-by-step instructions for installing a SIM card or USB stick.
Table of checks to perform before powering up the system.
Ensuring correct mast position for Dozers and Graders without slope sensors.
Steps to open the sensor selection menu.
Explains manual and seek modes for changing reference height.
Steps to use the Tri-Sonic sensor for sideshift control on a grader.
Instructions for entering the sensor calibration wizard.
Description of the display elements in the 3D Run screen.
Steps to store measured points, including coordinate files and point names.
How to use the auto logging function in run screen with fix position.
Description of avoidance zones and their characteristics.
Function to move the reference model vertically up or down.
Adjusting blade height as it wears down, manually or automatically.
Introduction to working with TIN models.
Functionality to hold cross slope in terrain models.
Comprehensive tool for searching and locking prisms with a Leica TPS.
Overview of supported search methods for different Leica TPS models.
Function for excluding stationary targets; adding targets to exclusion list.
Establishing a Bluetooth connection between TPS and iCON 3D.
Introduction to the iCON gps 80 receiver and its connection.
Settings for using the internal radio for RTK communication.
Settings for using NTRIP for RTK communication.
General information about system servicing and periodic checks.
Guidelines for storing the equipment respecting temperature limits.
Directions to anticipate and avoid operational hazards.
Permitted uses and adverse uses of the product.
Warnings about product repair, installation, and operation hazards.
Explanation of EMC and warnings about radiation disturbances.
Technical specifications for the iCP42, including ports and dimensions.
Operating/storage temperatures, water/dust protection, and humidity.
FCC Part 15 compliance and European Directive compliance.
Terms and conditions for the product's international limited warranty.
Terms and conditions for the software license agreement.
To Next Page
