LEIF GUIDE | 19
WWW.LEIFTECH.COM/GUIDE
The board is slow or range is
very low
Loud sound from the belts
during riding
Loose screw(s)
Battery has very little range
Bottom row of lights flashing on
Flight Deck
Battery lid repeatedly falls out
Motors are making
“clicking” sounds
Most likely a bearing is causing friction and needs to be
replaced. To confirm the bearing is bad, remove the belts
and see if the wheel spins freely by spinning with your
hand. Replace the bad bearings by undergoing the wheel
replacement procedure.
Most likely, one of the timing belts has lost its grip and
needs to be replaced. Those familiar with timing belts
will know this sound well. Undergo the belt replacement
procedure if the belts are worn.
Use thread locking liquid to keep screws from coming
loose. Use a very small drop of blue liquid on the screw
threads and re-insert screw.
If you have confirmed there is no bearing friction
happening, then most likely the battery was damaged
physically or was damaged from being left plugged into
the board overnight.
Power cycle the battery. If this continues after power
cycling, then you know the battery is dead.
First, try tucking the cords deeper in the inner space next
to the battery, they could be pushing the lock tabs out.
It could be due to physical damage as a result of the
battery not being strapped in tightly.
Contact support@leiftech.com to order a replacement
battery lid.
One of the motor pulley set screws are loose. Please
register in the forum and see videos at
www.leiftech.com/repair.
CAUSE OF PROBLEM
TROUBLESHOOTING
CORRECTIVE ACTION
LEIFTECH.COM/REPAIR
RECOMMENDED REPAIR TOOLS
• #2 PHILLIPS HEAD
SCREWDRIVER
• FLAT HEAD SCREWDRIVER
• ADJUSTABLE WRENCH
• C-CLIP WRENCH
To Next Page
Loading...