1
3
5
2
UPPER SUPPORT
X 4PCS
X 1PC
X 1PC
X 32PCS
X 4PCS
X 16PCSX 16PCS
X 8PCS
STEP 1:
STEP 2:
Mallet
Socket & Wrench
Phillips
Screwdriver
Tools Required for Assembly
13mm
STEP 5:STEP 4:
LEG
1S x 2PCS
1P x 2PCS
4 6
STEP 3:
1. Do not tighten bolts until fully assembled.
2. Recessed holes to face outward.
3. Insert bolts with washer and secure with washer and nut.
4. Pre-checked side must always face downward or inward.
IMPORTANT: READ CAREFULLY BEFORE BEGINNING
Recessed Hole
Pre-Checked
PARTS AND HARDWARE LIST
Tools Included
LOWER SUPPORT
X 4PCS
SHAFT
CROSS BRACE
7
A
Congratulations
on your assembly!
N08-11
B
D E
S04-5
C
STAKE
PLATFORM
WINDMILL HEAD
NUT & BOLT
B
5
B
C
6
2
Fit the Shaft (5) between the angles at the
top of the legs: Secure with the screws (B)
using a standard or electric drill.
Assembling
Place the Windmill Head (7) on the Shaft (5)
Slide the Platform (6) through
the Shaft (5), and secure with
the Screws (B). Fix the Cross
Braces (2) on to the legs
with the screws (C)
Tighten all Bolts and Screws
8
S04-3
ITEM#:
TX 93465, TX 93457
X 4PCS
CLAMP
Please tighten the Clamp (E) on each
windmill leg (about 8cm to the end ),
in order to avoid the wooden legs
cracked when insert the Stakes (D)
into the ground.
D
E
CHAR-LOG
®
WINDMILL
Do not fully tighten the bolts.
Connect the Upper Support (3) and the
Lower Support (4) between the Legs by
using the Bolts (A x 16).
2P
3
A
A
4
1S
1S
1P
1P
A
Separate assembly instructions
included in box with windmill head.
Assemble the Windmill Head (7),
make sure the Stop Nut is screwed
on well.
Overhead View
1P
1P
1S
1S
Length: 13.5”
Need help?
General
To Next Page
