Leigh Country METAL BENCH TEXAS STATE SEAL TX 93545 User Manual

ITEM # TX 93545
IMPORTANT: READ CAREFULLY BEFORE BEGINNING!
Make sure that all parts and hardware are present
before assembly.
Assemble on an a non-marring and level surface
Do not completely tighten all nuts and bolts until
the bench is fully assembled.
PARTS & HARDWARE LIST
BACK PANEL
SEAT PANEL
ARM FRAME
BOLT M6
HEX NUT
PLASTIC NUT COVER
WRENCH
A
B
C
D
E
F
G
10
2
1
1
2
10
10
PART# DESCRIPTION QUANTITY
1. (SEE FIGURE 1) Take the Seat Panel (B) and align the holes to the holes of the Arm Frame (C) and secure by inserting Bolts (D) through the Arm Frame then
Seat Panel. Secure the Bolts (D) with the Hex Nuts (E) on the inside of the Seat Panel. Repeat for the other the Arm Frame (C).
Do not fully tighten the Nuts and Bolts.
2. Slide the Back Panel (A) between the Arm Frames (C) and align the holes. Secure by inserting Bolts (D) through the Arm Frame then Back Panel (A). Secure
the Bolts (D) with the Hex Nuts (E) on the inside of the Back Panel. Repeat for the other the Arm Frame (C).
3. Once all Hex Nuts and Bolts are secured, tighten all Bolts (D) with the Wrench (H).
4. Slide Plastic Nut Covers (F) over all exposed bolt ends.
Congratulations
on your assembly!
Figure 1
RIGHT
LEFT
A
E
E
E
E
D
D
D
D
D
D
D
D
D
D
E
E
E
E
F
F
F
F
F
F
F
F
B
C
C
METAL BENCH TEXAS STATE SEAL

Leigh Country METAL BENCH TEXAS STATE SEAL TX 93545 Specifications

General

Brand	Leigh Country
Model	METAL BENCH TEXAS STATE SEAL TX 93545
Category	Outdoor Furnishing
Language	English

Summary

Assembly and Product Information

Important Pre-Assembly Checks

Review all parts and hardware before beginning assembly on a level, non-marring surface.

Parts Identification and Quantity

Details the required parts (A-B) and hardware (D-G) with their respective quantities for assembly.

Step-by-Step Assembly Guide

Instructions for attaching seat, back panels, and arm frames using provided bolts and nuts, followed by tightening.

Warranty and Product Care

Limited One Year Warranty

Covers defects in material and workmanship for one year from purchase under normal use and proper care.

Product Care and Maintenance

Guidance on cleaning with mild soap and water, and recommendations for storage during periods of non-use.