STEP 3STEP 2
STEP 4 STEP 6STEP 5
I
G
H
D
E
F
C
K
J
A1 (TOP) = 3PCS A2 (BOTTOM) = 3PCS
B = 1PC
E = 1PC
G = 1PC Rudder
H = 1PC Fan Blades
I = 1PC Stop Nut
M4 X 0.4”
M6 X 1.6”
J = 9PCS
K = 6PCS
L = 3PCS
D = 1PC
C = 3PCS
F = 1PC
Windmill Legs
Star Platform
Windmill Head Screws
Top Mount Platform
Decor Cap
Side Panels
Needle (Screw into B)
Ground Stakes
I
G
H
A
D E
J K
L
L
L
L
G H I
F
B C
Tools Required for Assembly:
#2 Phillips Screwdriver
10” Adjustable Wrench
STEP 1
A
A1
A2
J
B
F
IMPORTANT: READ CAREFULLY BEFORE BEGINNING!
Make sure that all parts and hardware are present
before assembly.
Assemble on a non-marring and level surface
Do not completely tighten all nuts and bolts until
the bench is fully assembled.
WINDMILL 9FT. TRIPOD TEXAS FLAG
ITEM #: TX 93480
Secure the Needle (F) into the Top Mount Platform (B).
Secure the Top Mount Platform (B) to the top of the Legs
(A1) with the Screws (J). Connect top portion of Legs
(A1) to the bottom part (A2). Leg should face inwards.
Affix the Side Panel (C) into place between the Windmill
Legs (A), tighten with the Bolt & Nut (K).
Place the Directional Cap (E) on the Top Mount Platform
(B), lock into place with the Needle (F).
Assemble the Windmill Head (G, H, I), make sure the Stop
Nut (I) is screwed on well.
Note: The front hole of the Fan Blades (H) is larger than
the back hole.
Place the Windmill Head (G, H, I) on the Needle (F). Secure the
Windmill by inserting the Ground Stakes (L) through each
hole at the base of each legs.
Assembling
Affix the StarPlatform (D) on top of the Windmill Legs (A),
and tighten with the Screws (J).
PARTS AND HARDWARE LIST
Congratulations
on your assembly!
K
To Next Page
Need help?
General
