NET Series
Software Operation
LEIGHTRONIX, INC. Firmware Ver. 1.00.42/Software Ver. 1.0.2.6 Page 95
2010-07-09
2. If an output assignment is desired, the output must be selected from the drop
down menu.
3. A date and/or day(s) must be selected as follows:
NOTE: If a date is selected, the event happens on that date. If days are
selected, the event happens on those days. If both are selected, the
event happens on the date and on the days.
a. To select a date, change “Absolute date” to “Yes.” A date field appears
below to allow date entry.
b. To enter a day, change the desired day field(s) to “Yes.” These fields can
be toggled quickly by double clicking on the day name.
4. You may edit the properties of a resource that has ONLY been dragged into the
“Playlist” of the WinNET-LT tab by performing the following steps:
a. Select “Option” under the “Tools” menu.
b. Select the “Application” tab of the “Configuration” window. Check the “Allow
global resource property changes” checkbox.
c. Click on the desired editable fields in the “Properties” window and make
changes.
d. WinNET displays a dialog box that gives you the option to merge the
resource editing changes into all events in the WinNET-LT tab that were
created from the same resource.
Copying/Cutting/Pasting an Event
To move or replicate an event or group of events to another location on the playlist,
select the desired event(s). Copy, cut (if you wish to move event), and paste by
selecting the function you wish to perform from either the “Edit” menu or in the
right-click popup menu.
In the “Event Properties” box that appears once the paste has been completed,
click “Ok” if one event was pasted or “Ok to all” if more than one event was pasted.
In the day channel tabs, WinNET will abort the paste and display an error message
specifying the problem if the events surrounding your chosen location conflict in
date or time with the pasted event.
Editing an Event
To edit an event in the playlist, double click event or right click event and choose
“Edit” in the popup menu that appears. Edit the event information in the “Event
properties” box that appears. To add or change the event information, click on
each of the desired editable fields (described in the following sections) and enter
the new information.
To Next Page
Loading...
