Leine & Linde 607 - User Manual

Ensure power is off and machine is stopped before mounting to prevent injury.

Lists parts for fieldbus encoders and those with SSI/EnDat interfaces.

Risks from ESD, mechanical forces, moisture, temperature, vibration, and impacts.

Risks from short circuits and excessive supply voltage.

Step-by-step guide for mounting encoders with hollow shafts.

Mounting encoders with synchro or clamping flanges, including alternatives.

Verifying shaft dimensions, runout, and using couplings.

Proper use of shielded cables, managing length, bending radius, and interference.

Detailed steps for fitting cables to connectors and glands.

Configuring node addresses and baud rates for different protocols.

Procedures for bus termination using resistors or switches.

Product conformance to UL/CSA standards, CE marking, and EMC requirements.

Details on shaft couplings and mounting clamps/brackets.