1
LEISTER Triac PID
Hot Air Blower
Read operating instructions carefully before
use and keep it for further reference.
• Welding of thermoplastic materials as well as single-ply flexible plastics and
modified bitumen in the form of boards, tubes, profiles, lining membranes,
coated materials, films, foams, tiles, and sheets. The following procedures
are possible: overlap welding, welding with rod, with tape, butt welding
and melt welding
• Heating-up for forming, bending and sealing of thermoplastic semi-
finished materials and plastic granules
• Drying of water-damp surfaces
• Shrinking of heat-shrink sleeves, films, tapes, solder sleeves and moulded parts
• Soldering of copper pipes, solder joints and metal foils
• Defrosting of frozen water pipes
• Activating/dissolving of solvent free adhesives and fusion adhesives
• Igniting of wood shavings, paper, coal or straw in furnaces
OPERATING INSTRUCTIONS
APPLICATION
®
LEISTER Process Technologies, Riedstrasse, CH-6060 Sarnen/Switzerland
Tel. +41 41 662 74 74 Fax +41 41 662 74 16
www.leister.com sales@leister.com
GB
USA
To Next Page
Need help?
General
