Lay the jumping mat with the safety net
inside frame.
Note: Before attaching the springs,
ensure that the entrance of safety net is
between the two legs and in the middle.
Attach one small hook end of spring
into one of the triangle rings on the
mat and insert another big hook end
of spring into the hole of the frame
tube beside one T connector by
spring loading tool.
Repeat to attach springs beside
each T connector by counting
the number of springs and
corresponding holes on frame
tube shown as above picture.
Attach all other springs evenly.
WARNING: Trampoline is under heavy
tension, more effort may be required to
attach the springs to the frame. Be careful
not to pinch fingers or slip. Serious injury
may occur.
Lay the frame pad around on top of
springs only with flaps hanging over
outside frame, then stick the Velcro
together. Adjust the pad’s placement
and make sure each seam aligned
with each T-tube connector.
Tie all black straps under safety
pad to the frame tubes like above
picture.
Hang all the elastic strips under safety
pad to the nearest spring hooks.
Insert fiberglass poles into the top
pathway of safety net one by one. Join
the ends of two fiberglass poles
together by silver connector. (If there
is a shorter pole, then assemble it at
last.)
Connect each upper safety pole and
lower safety pole together by the pin
and make sure the pin locked.
To Next Page
Loading...