www.lekkie.Techlekkie onenuT user Manual
At Lekkie we don’t accept anything but the best workmanship and quality. If a part has slipped through our
QC system and made it to your hands let us know and we will put it right.
If one of our products fails we want to know so we can make our products better. If you destroy a lekkie
product in extreme use tell us. We can learn from this and sell you something to suit your needs.
If you are in any way unhappy with your Lekkie product get in touch so we can put it right.
WARRANTY
3. Lock the ONENUT in place by tightening the 2x Grub Screws to a maximum of 2Nm. Tighten
until the Grub Screw feels like it is starting to bottom out then tweak it up slightly, just enough
to spread the ONENUT open slightly and lock the thread in place.
Note: If the main thread is not fully engaged, reduce the locking screw torque. A small amount of
additional Loctite 243 can be used if required.
4. To remove the ONENUT simply loosen the Grub Screws and unscrew the nut with the 16 notch
tool.
To Previous Page
Loading...