Pag. 4
PROBLEM CAUSE SOLUTION
Coffee is produced
without froth.
1. Coffee not suitable for machine
2. Improper grind
3. Too little coffee in filter
4. The filter holder has not be tightened
under the brewing group ring
1. Use different coffee
2. Adjust coffee grind
3. Put more coffee in the filter
4. Tighten better the filter holder
Coffee too cold
1. The machine had not reached the
proper temperature
2. Filter-holder not preheated
3. Cups not preheated
4. Pressure switch malfunction.
1. See section “Starting the Machine” and “Making
an Espresso Coffee”
2. Filter-holder must be heated together with the
water – see section “Starting the Machine”
3. Properly heat the cups on the cup-warmer
4. Contact the nearest SERVICE CENTER
Coffee produced too
quickly
1. Coffee too coarsely ground
2. Not enough coffee in the filter
3. Coffee not pressed enough
4. Coffee/pod old or unsuitable
1. Use a finer grind
2. Put more coffee in the filter
3. Press coffee more firmly
4. Use different coffee/pod
Coffee leaks
between the coffee
group and the filter-
holder
1. Filter-holder not properly inserted
2. Too much coffee in the filter
3. Edge of the filter-holder not clean
4. The douche seal is worn or damaged
1. Insert the filter-holder correctly
2. Put less coffee in the filter
3. Clean the edge of the filter-holder
4. Contact the nearest SERVICE CENTER
Coffee is produced in
drips
1. Coffee too finely ground
2. Too much coffee in the filter
3. Coffee too firmly pressed
1. Use a coarser grind
2. Put less coffee in the filter
3. Press the coffee more gently
The machine does
not produce steam
1. Obstructed outlet hole at end of
steam pipe
2. Too little water in tank
1. Clean the outlet hole with a needle
2. See section “Starting the Machine”
No coffee produced
during the coffee
cycle
1. Too little water in tank
2. Steam switch on
3. Coffee too finely ground
4. Too much coffee in the filter
5. Coffee too firmly pressed
6. Shower plate obstructed
1. Fill tank
2. Turn off the steam switch
3. Use a coarser grind
4. Put less coffee in the filter
5. Press the coffee more gently
6. Contact the nearest SERVICE CENTER
The machine does
not work and the ON
light does not turn
on
1. No electricity
2. The main cable is not properly
plugged in
3. The main cables damaged
1. Restore electrical power
2. Plug the main cable in correctly
3. Contact the nearest SERVICE CENTER for a
replacement cable
The ON light is on
but the water does
not heat
1. Thermostat malfunction,
2. Heating element malfunction
1. Contact the nearest SERVICE CENTER
2. Contact the nearest SERVICE CENTER
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH EC DIRECTIVE 2002/96/EC
At the end of its working life, the product must not be disposed of as urban waste. It must be
taken to a special local authority differential waste collection centre or to a dealer providing this
service. Disposing of a household appliance separately avoids possible negative consequences
for the environment and health deriving from inappropriate disposal of enables the constituent
materials to be recovered to obtain significant savings in energy and resources. As a reminder
of the need to dispose of household appliances separately, the products is marked with a
crossed-out wheeled dustbin.
EC DECLARATION OF CONFORMITY
Gemme Italian Producers srl declares under its own responsibility that the products
PL042EMI/
PL042EMIAUS,
to which this declaration relates, are in accordance with the
provisions of the specific directives:
CEI EN 60335-1, CEI EN 60335-2-15
It also declares that the above mentioned products conform with the electromagnetic
compatibility test EMC.
NB: The present declaration voids should the machine be modified without our specific
authorization.
Castegnato, 02/01/2013
Amministratore Delegato
AB 01
Gemme Italian Producers srl
Via del Lavoro 45 - I - 25045 Castegnato (BS) Italy
Tel: +39 030 2141199 - Fax: +39 030 2147637
www.lelit.com - lelit@lelit.com - P.Iva 03426920173
To Previous Page
Loading...
